This command shuts down all the jBASE printr demons. To use this command you have to have Administrator privileges on Windows or root privileges on Unix.
After typing the command you will either get:
Which means that there are no jspprint daemons running to shut down.
Or you will get a list of queues with their PID numbers shown and you will be asked if you want to shut them down e.g.
If you hit return or type N you will get the following message and the program will exit:
If you type Y then the program will try to tidy shut the processes down and then will sleep for 30 seconds to allow the daemons to shut themselves down e.g.:
If this was successful then you will get the following message and the program will exit:
If this process was not successful then the remaining daemons will be displayed and you will be asked if you want to kill the daemons e.g.:
If you hit return or type N then you will get the following message and the program will exit.
If you type Y then the program will try to kill the processes. The program will tell you whether the kill was successful:
Or Unsuccessful, If it is unsuccessful then you will get some type of error message followed by:
When the kill fails the error message it gives before the above should be reported to your support company so it can be investigated further.