BASIC -v -wn -Ipath FileName Itemlist (On En Wn Ipath Qq

Option Description
-v verbose mode
-wn set the warning level to 0, 1, 2 or 3. See later
-Ipath path for include files
(On optimize the code, see below
(En optimize the code. As the (O) option
(Wn set warning level to 0, 1, 2 or 3, see below
(Ipath path for include files
(V allow persistent variables in subroutines
(Qq specifies that the source code contains embedded SQL statements, see below

If the record key selection is omitted, BASIC will use any preceding select list. If the BASIC command has no select list, it will use all records in the specified file. When processing the list of record keys, the BASIC command will ignore $ and ! prefixes and .o or .obj suffixes and build up a list of source names. Using this mechanism, you can safely use BASIC on all records in a file, and it will only process the sources you intended. The jbc and BASIC commands allows 4 levels of warning to be generated.

For example, to set warning level 3 use either of the following commands:


The jbc command uses the -JCwn option, where n is the warning level from 0 to 3.
For example, to set warning level 3 use the following command:

jbc -Jcw3 FILENAME.b -c

Note: To copy binary object files such as $PROG or PROG.o from Hash files to directories or vice versa use the B option of the jBASE COPY command. This will ensure conversion of attribute mark characters to new line and vice versa is suppressed thus invalidating the binary object.



There are 4 levels of optimization.

Level Description
1 No code optimizations are performed and debug information is produced for both the C debugger and the jBASE debugger.
2 Debug information is produced for the jBC debugger but not for the C debugger. Minimal optimization occurs. This is the default optimization level.
3 Debug information is produced for the jBC debugger. Optimization of jBC occurs and matrix boundary checking is removed. The C code is optimized by the standard optimizations of the resident C compiler.
4 Full optimization. No debugging information is produced. The jBC code is fully optimized and no run time checking is done on array boundaries and the like. All symbol information is removed from the final executable and all available (safe) optimizations are performed by the resident C compiler.



The default level is level 1.

The four levels are:

Level Type Description
0 none no warnings generated at all
1 reasonable reports likely coding errors
2 pedantic reports level 1 warnings and bad practice
3 very pedantic reports every transgression of the rules

The following source code can be used to show the different warning levels in action. Each warning level will produce a different set of warning messages. The higher the warning level the more warning messages will be generated.

varx = 1
vary = varz
FOR I = 1 TO 10
format = varx "L#10" "L#20" "L#30"



The Qq option is used to specify that the source code contains embedded SQL statements. The values for q can be:

Option Description
i Ingres
m Microsoft SQL
o Oracle
x Informix